騰達試驗儀器廠：

　　橡膠壓縮變形測定儀是測量橡膠,硫化橡膠,熱塑性橡膠的**設備，使用前務必仔細閱讀說明書。

　　Rubber compression permanent deformation tester is the best equipment for measuring rubber,vulcanized rubber and thermoplastic rubber.Please read the manual carefully before use.

　　橡膠壓縮變形測定儀橡膠壓縮變形器概述

　　試驗器由平行鋼板限制器和緊固件組成,符合GB7759、ISO815要求,用于硫化橡膠,熱塑性橡膠在常溫,高溫和低溫條件下,以一定壓縮率,經一定的壓縮時間后測定橡膠變形量。

　　Rubber compression set

　　The tester consists of parallel steel plate limiters and fasteners,which meet the requirements of GB7759 and ISO815.It is used for vulcanized rubber.Thermoplastic rubber is measured at room temperature,high temperature and low temperature with a certain compression rate and a certain compression time to determine the rubber deformation.

　　橡膠壓縮變形測定儀技術參數:

　　★試樣:

　　A型直徑29mm高度12.5mm

　　B型直徑13mm高度6.3mm

　　★限制器高度:試樣類型A B

　　壓縮率25%時9.3～9.4 4.7～4.8

　　壓縮率15%時10.6～10.7 5.3～5.4

　　壓縮率10%時11.25～11.3 5.65～5.7

　　★外形尺寸:直徑115mm高110mm

　　★重量:10Kg

　　Technical parameters of rubber compression permanent deformation tester:

　　★Sample:

　　Type A diameter 29mm height 12.5mm

　　Type B diameter 13mm height 6.3mm

　　Limiter height:sample type A B

　　When the compression rate is 25%9.3 to 9.4 4.7 to 4.8

　　When the compression rate is 15.6 to 10.7 5.3 to 5.4

　　When the compression ratio is 10.25～11.3 5.65～5.7

　　★Dimensions:115mm in diameter and 110mm in height

　　★Weight:10Kg