具體成交價以合同協議為準
￥面議
從峰工業(yè)科技（上海）有限公司
免費會員產品介紹
寶德6013電磁閥125314型號
電磁閥常見的故障分析，供參考：
電磁閥卡?。弘姶砰y的滑閥套與閥芯的配合間隙很?。ㄐ∮?/span>0.008mm），一般都是單件裝配，當有機械雜質帶入或潤滑油太少時，很容易卡住。處理方法可用鋼絲從頭部小孔捅入，使其彈回。根本的解決方法是要將電磁閥拆下，取出閥芯及閥芯套，用CCI4清洗，使得閥芯在閥套內動作靈活。拆卸時應注意各部件的裝配順序及外部接線位置，以便重新裝配及接線正確，還要檢查油霧器噴油孔是否堵塞，潤滑油是否足夠。
寶德6013電磁閥125314型號
The solenoid valve is stuck: the valve sleeve of solenoid valve is small (less than 0.008 mm) with the valve core, and it is usually single assembly. When mechanical impurities are brought in or the lubricating oil is too low, it is easy to get stuck. The treatment method can be used to push the wire through a small hole in the head to make it bounce back. The ultimate solution is to remove the solenoid valve, remove the valve core and the valve core sleeve, and use CCI4 cleaning to make the valve core move flexibly inside the valve sleeve. The assembly sequence of the parts and the external wiring position should be paid attention to, in order to reassemble and connect correctly, and check whether the oil spray hole is blocked and the lubricating oil is sufficient.
更多的寶德產品信息歡迎您隨時與我們。
相關產品
-
-
￥面議
